
Thank you for reading our post, please rate this article at the end.
Reading Time: 3 minutesLast Updated on October 29, 2026 by Paul Clayton
To use anti-sway bars on a travel trailer, hitch the trailer, attach the friction sway bar between the ball on your hitch head and the ball welded on the trailer tongue, then tighten the adjustment handle until the bar resists side-to-side movement without binding. Loosen or disconnect a friction bar before backing up sharply and on slippery roads, and follow your hitch maker’s instructions. Sway bars work best with correct tongue weight, about 10 to 15 percent of the trailer’s weight, and a properly set weight-distribution hitch.

Table of Contents
Key Takeaways
| Topic | Quick answer |
|---|---|
| What sway bars do | Add friction to dampen side-to-side trailer movement |
| Where they mount | Between the hitch head and the trailer tongue |
| How tight | Snug enough to resist sway, per the maker’s spec |
| When to loosen | Sharp backing, wet or icy roads (friction bars) |
| Tongue weight | About 10% to 15% of loaded trailer weight |
What Causes a Trailer to Sway?
- Too little tongue weight or heavy items at the rear
- Crosswinds and passing trucks
- High speeds and sudden steering
- Underinflated tires; see RV tire pressure monitoring systems
- A tow vehicle that’s too light for the trailer

How to Avoid Trailer Sway
Load heavy gear low and over the axles, keep tongue weight in range, slow down in wind and use a weight-distribution hitch with sway control. If sway starts, ease off the gas, keep the wheel straight and gently apply the trailer brakes with the controller.
How Anti-Sway Bars Work
A friction sway bar uses a sliding bar inside a housing with brake-like pads. Turning the handle increases friction, which resists the trailer pivoting on the hitch ball. Other systems use cams or integrated dampers built into the hitch head.
How to Use Anti-Sway Bars on a Travel Trailer
- Hitch the trailer and set up weight distribution if you use it.
- Install the sway bar ball on the trailer tongue and hitch head if not already done.
- Attach the bar ends to both balls and secure the pins.
- Tighten the handle to the manufacturer’s setting.
- Test drive at low speed and adjust if needed.
- Loosen before tight backing maneuvers and in slick conditions.

Drawbacks
- Friction bars must be loosened for sharp turns and backing.
- Less effective on wet or icy roads.
- They don’t fix bad loading or an undersized tow vehicle.
How Tight Should a Sway Bar Be?
Tight enough to resist sway but loose enough to allow normal turns. Many friction bars specify a number of turns past snug; follow your manual. More details from Crossroads Trailers on sway bars.

More towing help: single vs double axle travel trailers, trailer hitch locks and how much an Airstream weighs.
FAQ: Anti-Sway Bars on a Travel Trailer
Do I need a sway bar for a small travel trailer?
It’s often recommended for trailers over a few thousand pounds and in windy areas.
Can I back up with a sway bar on?
Straight backing is usually fine, but loosen friction bars for sharp turns.
Do I need one or two sway bars?
Heavier trailers sometimes use two; follow your hitch maker’s guidance.
Is a weight distribution hitch the same as a sway bar?
No, but many weight-distribution hitches include sway control.
Final Thoughts
Using anti-sway bars on a travel trailer is simple: attach, tighten to spec and loosen when needed. Combine them with good loading and proper tongue weight for a calm, safe tow.
Resources
- Hitch and sway control manufacturer instructions
- NHTSA, towing safety




