
Thank you for reading our post, please rate this article at the end.
Reading Time: 4 minutesLast Updated on November 15, 2026 by Paul Clayton
Blowing out RV water lines vs antifreeze? Both methods protect your plumbing from freezing. Blowing out the lines with compressed air is cheap, chemical-free and quick to undo in spring, but it can leave small pockets of water behind. Pumping RV antifreeze through the lines gives more complete protection, especially in very cold climates, but costs more and leaves a taste you’ll need to flush out. (Wondering where it goes afterward? See if RV antifreeze can go down the drain.) Many RVers combine them: blow out the lines first, then add antifreeze to the drains and, in hard-freeze areas, the supply lines too.

Part of our guide: How to Winterize an RV: Complete Step-by-Step Guide
Table of Contents
Key Takeaways
| Topic | Key takeaway |
|---|---|
| Blowing out | Uses compressed air to push water out of the lines |
| Antifreeze | Fills lines and traps with non-toxic RV antifreeze |
| Best protection | Many RVers do both: blow out, then add antifreeze to traps |
| Air pressure | Keep it low, around 30 to 40 psi or per your manufacturer |
| Water heater | Drain and bypass it either way |
Blowing Out vs. Antifreeze at a Glance
| Blowing out with air | RV antifreeze | |
|---|---|---|
| Protection | Good if done thoroughly; small amounts of water can remain in low spots | Very good; liquid in the lines won’t burst pipes down to its rated temperature |
| Cost | Low after you own a compressor and blow-out plug | Several gallons every year |
| Spring prep | Little to flush | Must flush and often sanitize to remove taste |
| Skill needed | Moderate; too much pressure can damage fittings | Easy with a pump converter or bypass kit |
| Best for | Mild climates, quick trips between cold snaps | Long storage in freezing climates |
How to Blow Out RV Water Lines

You’ll need an air compressor with a regulator and a blow-out plug that screws into your city water inlet.
- Turn off the water heater and water pump, and let the water heater cool.
- Drain everything. Open the fresh tank drain, low-point drains and water heater drain plug, and dump the gray and black tanks.
- Bypass the water heater so you’re not trying to blow out a full tank.
- Set the regulator low. Around 30 to 40 psi is commonly recommended. High pressure can damage fittings and seals.
- Connect the blow-out plug to the city water inlet and attach the air hose.
- Open one faucet at a time, hot then cold, until only air comes out. Do the shower, outdoor shower, toilet valve and any ice maker or washer lines.
- Repeat the whole round once or twice to clear remaining water.
- Close the low-point drains and leave faucets slightly open.
- Add antifreeze to every P-trap and the toilet bowl, since air can’t protect water sitting in traps.
How to Winterize With RV Antifreeze

- Drain the system the same way: fresh tank, low points, water heater and holding tanks.
- Bypass the water heater so you don’t fill it with antifreeze. See whether you can put RV antifreeze in your hot water heater.
- Connect antifreeze to the pump with a pump converter kit or tube from the jug.
- Turn on the pump and open each faucet, hot then cold, until pink antifreeze comes out. Work from the closest fixture to the farthest.
- Flush the toilet until antifreeze appears, and pour some into each drain.
- Turn off the pump and close the faucets.
Use only non-toxic RV antifreeze, never automotive coolant. Most RVs need around 2 to 3 gallons with the water heater bypassed. For reuse and disposal, see whether RV antifreeze can be reused and whether it will kill grass.
Which Should You Choose?
- Mild winters with occasional freezes: blowing out the lines plus antifreeze in the traps is usually enough.
- Long, hard freezes: antifreeze in the supply lines gives the most security. Blowing out first means less water to dilute it.
- You camp in winter: blowing out is quicker to reverse between trips.
- You hate the taste: blow out and use antifreeze only in drains, or plan to sanitize in spring.
Getting Ready in Spring
If you used antifreeze, flush the lines with fresh water until it runs clear, then sanitize the system. Our guides to cleaning an RV water system with vinegar and whether RV antifreeze sanitizes help with that. Reinstall the water heater drain plug and close the bypass before turning the heater back on.
Blowing Out RV Water Lines vs Antifreeze FAQ
Is blowing out RV lines enough to winterize?
In many climates, yes, if you do it thoroughly and add antifreeze to the P-traps and toilet. In very cold areas or for long storage, adding antifreeze to the lines is safer.
What psi should I use to blow out RV water lines?
Around 30 to 40 psi is commonly recommended. Use a regulator and avoid high shop-compressor pressure.
Do I still need antifreeze if I blow out the lines?
Yes, for the drain traps and toilet. Many owners also add it to the lines in hard-freeze climates.
Can I use the city water inlet to blow out the lines?
Yes. A blow-out plug screws into the city water connection and lets you attach an air hose.
Final Thoughts
Blowing out lines saves antifreeze and avoids the taste in spring, while antifreeze gives extra protection in low spots. In very cold climates, combining both is the safest approach. Follow your RV manual and our winterizing guide for the full process. New to winterizing? Start with what RV antifreeze is and how the types differ.
Resources
- RV manufacturer winterizing instructions
- RV antifreeze manufacturers’ product labels




